Kia Sorento: IPM Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
|
| 3. |
Remove IPM(Intelligent intergrated Platform Module) connector
(A), bolts and nut
|
| 4. |
Remove IPM after removing rear connectors.
|
IPM Function
1.
Wiper & Washer Control
(1)
Front Washer Interlocking Wiper Control
If washer switch (WasherSW) is ON at the status of IG ...
IPM Installation
1.
Install IPM(Intelligent intergrated Platform Module).
2.
Connect the IPM connector.
3.
Install the crash pad ...
See also:
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetooth pairing (searching) mode
Userв ...
Engine Room Under Cover Components
1. Under Cover
2. Side Cover (RH)
3. Side Cover (LH)
...
Fuel Tank Air Filter Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
Copyright В© www.ksmanual.com 2014-2024