Kia Sorento: License Lamps Installation

License Lamps Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. ...

High Mounted stop lamp Removal

High Mounted Stop Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the tailgate trim. (Refer to Body - " ...

See also:

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Cooling Fan Control Module Circuit Diagram
...

Description
BSD is a system that uses two magnetic wave radar sensors attached on the rear bumper to measure the distance from the following vehicles and provides the sensing and (visual and auditory) al ...