Kia Sorento: Power Seat Motor Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Inspection
Power Seat Motor
| 1. |
Disconnect the connectors for each motor.
(Refer to Body - "Front seat")
|
| 2. |
With the battery connected directly to the motor terminals, check
if the motors run smoothly.
|
| 3. |
Reverse the connections and check that the motor turns in reverse.
|
| 4. |
If there is an abnormality, replace the motors.
|
Component Location
1. Slide motor
2. Front height motor
3. Rear height motor
4. Lumber support motor
5. Power seat switch
6. Reclining motor
7. Reclining switch
8. Lumber support swit ...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS)
Torque converter control solenoid valve (T/CON) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the torque converter.
...
Immobilizer Control Unit Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel (A).
(Refer to Body - "Crash pad")
...
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a bulb check.
The l ...
Copyright В© www.ksmanual.com 2014-2024