Kia Sorento: Power windows - Windows - Features of your vehicle - Kia Sorento XM Owners ManualKia Sorento: Power windows

Second Generation XM (2011-2024) / Kia Sorento XM Owners Manual / Features of your vehicle / Windows / Power windows

The ignition switch must be in the ON position for power windows to operate. Each door has a power window switch that controls the door's window.

The driver has a power window lock button which can block the operation of passenger windows. The power windows can be operated for approximately 30 seconds after the ignition key is removed or turned to the ACC or LOCK position. However, if the front doors are opened, the power windows cannot be operated even within the 30 second period.

✽ NOTICE

While driving with the rear windows down or with the sunroof (if equipped) in an open (or partially open) position, your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is a normal occurrence and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly reduce the size of the sunroof opening.

Window opening and closing

The driver’s door has a master power window switch that controls all the windows


The driver’s door has a master power window switch that controls all the windows in the vehicle.

To open or close a window, press down or pull up the front portion of the corresponding switch to the first detent position (5).

Auto down window (Driver’s window, if equipped)

Pressing the power window switch momentarily to the second detent position (6)


Pressing the power window switch momentarily to the second detent position (6) completely lowers the driver’s window even when the switch is released. To stop the window at the desired position while the window is in operation, momentarily pull the switch in the direction opposite of the window’s movement.

Auto up/down window (Front windows, if equipped)

Pressing or pulling up the power window switch momentarily to the second detent


Pressing or pulling up the power window switch momentarily to the second detent position (6) completely lowers or raises the window even when the switch is released. To stop the window at the desired position while the window is in operation, pull up or press down and release the switch.

If the power window does not operate normally, the automatic power window system must be reset as follows:

1. Turn the ignition switch to the ON position.

2. Close the driver’s window and continue pulling up the driver’s power window switch for at least 1 second after the window is completely closed.

Automatic reversal (for Auto up/down window)


Automatic reversal (for Auto up/down window)

If the upward movement of the window is blocked by an object or part of the body, the window will detect the resistance and will stop upward movement. The window will then lower approximately 11.8 in. (30 cm) to allow the object to be cleared.

The distance may vary based on the size or position of the window. If the window detects the resistance while the power window switch is pulled up continuously, the window will stop upward movement then lower approximately 1 in. (2.5 cm).

And if the power window switch is pulled up continuously again within 5 seconds after the window is lowered by the automatic window reversal feature, the automatic window reversal will not operate.

✽ NOTICE

The automatic reverse feature for the driver’s window is only active when the “auto up” feature is used by fully pulling up the switch. The automatic reverse feature will not operate if the window is raised using the halfway position on the power window switch.

WARNING

Always check for obstructions before raising any window to avoid injuries or vehicle damage. If an object less than 4 mm (0.16 in.) in diameter is caught between the window glass and the upper window channel, the automatic reverse window may not detect the resistance and will not stop and reverse direction.

Power window lock button


CAUTION

WARNING - Windows

Windows
(1) Driver’s door power window switch (2) Front passenger’s door power window switch (3) Rear door (left) power window switch (4) Rear door (right) power window switch (5) Window opening and ...

Hood
...

See also:

LCD Modes
Trip Computer This mode displays driving information like the tripmeter, fuel economy, and so on. Service    This mode informs of service interval (mileage or days) and warning mess ...

Starter Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Hands Free Switch Removal
1. Remove the driver airbag module. (Refer to Restraint - "Airbag module") 2. Remove the steering wheel front cover (A) after ...

Copyright © www.ksmanual.com 2014-2024