1. |
Installation is the reverse of removal.
|
2. |
Compress the piston into the caliper body using the SST (09581-11000).
|
3. |
After installation, bleed the brake system.
(Refer to Brake system - "Brake system Bleeding")
|
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...
Specifications
▷ Type: Combination of output signals from 4 terminals
▷ Specifications
Power supply (V)
12
Output type
Pin to Pin
▷ Signal ...
Knock Sensor (KS)
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...