1. |
Disconnect the battery negative terminal.
|
2. |
Remove the fuse box cover.
|
3. |
Remove the starter relay(A).
|
4. |
Using an ohmmeter, check that there is continuity between each
terminal.
|
5. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
|
6. |
If there is no continuity, replace the starter relay.
|
7. |
Install the starter relay.
|
8. |
Install the fuse box cover.
|
Voice Command List
Common Commands:
These commands can be used in most operations. (However a few commands may not
be available during certain operations)
FM/AM radio commands:
Commands available during FM, ...
IPM Function
1.
Wiper & Washer Control
(1)
Front Washer Interlocking Wiper Control
If washer switch (WasherSW) is ON at the status of IG ...
Blind Spot Detection Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
...