Kia Sorento: Blind Spot Detection Switch Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Switch Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
|
| 3. |
Remove the crash pad side switch assembly (A) after loosening
the mounting screws.
|
Blind Spot Detection Switch Installation
1.
Install the crash pad side switch assembly after connecting the
connector.
2.
Install the crash pad lower panel.
...
See also:
Transfer Fluid Inspection
•
Transfer oil should be inspected and refilled every 60000
km (40000 mile) / 4 year.
...
Fuel Tank Air Filter Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
Rear Differential Carrier Reassembly
Pinion drive gear height adjustment
Adjust the height of the drive pinion in the following order.
1.
Below are the special tools to measure the pinion height
...
Copyright В© www.ksmanual.com 2014-2024