Kia Sorento: Fuel Tank Air Filter Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Tank Air Filter Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation tube quick-connector (B) from the fuel
tank air filter and canister close valve.
|
| 5. |
Disconnect the vapor tube quick-connector (A).
|
| 6. |
Remove the canister assembly bracket (D) after removing the mounting
bolts (B) and nut (C).
|
| 7. |
Remove the canister braket (B) installation bolt (A).
|
| 8. |
Remove the fuel tank air filter & canister close valve assembly
(A) after rotating it in the direction of the arrow in the figure.
|
| 9. |
Release the lever (A), and then separate the canister close valve
(B) from the fuel tank air filter (C) after rotating it in the direction
of the arrow in the figure.
|
Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the
chances of incorrect installation, which would seal the fuel filler. After the
gasket on the fuel filler cap and the fi ...
Fuel Tank Air Filter Installation
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped.
In this case, u ...
See also:
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cov ...
Fuel Pressure Control Valve
Fuel Pressure Control Valve is installed on the high pressure fuel pump
and controls fuel flow flowing into the injectors in accordance with the ECM
signal calculated based on various engine ...
Cooling Fan Components
1. Upper air guard
2. Cooling fan control module
3. Cooling fan shroud
4. Fan motor
5. Cooling fan
...
Copyright © www.ksmanual.com 2014-2024