• |
Install the component with the specified torques.
|
• |
Note that internal damage may occur when the component is dropped.
In this case, use it after inspecting.
|
1. |
Install in the reverse order of removal.
|
Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gently ...
Specification
Item
Specification
Rated Voltage
DC 12.0V
Operating voltage
DC 10.7 ~ 15V
Operating temperature
-30 ~ 75°C (-22 ~ 167°F)
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the connector (A), and then remove the sensor ...