Kia Sorento: Speakers Inspection
1. |
Troubleshooting for Speaker
(1) |
Basic inspection of speaker
Inspect the sound from speaker after verifying that the
speaker mounting screws is removed and the wiring connector
is connected precisely to remove vibration transmitted from
body trims and surrounding parts.
|
(2) |
Case Troubleshooting
No.
|
Case
|
Inspection/Remedy
|
1
|
Trembling sound
|
1. |
Before replacing the speaker, inspect
that the mounting screw is installed normally.
|
2. |
After re-installing the speaker, verify
that no trembling sound is heard.
|
3. |
When hearing a trembling sound again,
replace the speaker with new one.
|
|
2
|
Noise
|
1. |
Check if the wiring connector is connected
normally. If not, reconnect the wiring connector.
|
2. |
In case of radio static, check if there
is a noise from CD player.
|
3. |
When a noise is heard on turning radio
and CD on, replace the speaker with new one.
|
In case there is only radio static, this
causes from poor radio reception. Thus the speaker
needs no repair and replacement.
|
|
3
|
Poor working
|
Inspection of the wiring connection between the battery and
the speaker
1. |
Before replacing the speaker, inspect
the wiring connection between the battery and
the speaker is normal.
|
2. |
Check the supplying power to the speaker
and the resistance, and then inspect the sound
quality.
|
3. |
If the speaker works poorly, replace it
with new one.
|
|
- |
During dealing of speaker
|
- |
Do not damage the speaker with impact
as like a drop and a throw.
|
- |
Be careful not to cover water and oil
over the speaker.
|
- |
Caution during dealing of speaker because
the material of diaphragm is paper which is
easy to be torn by impact and external force.
|
- |
When modifying audio system as customer
pleases, this does electric damage to speaker.
|
- |
And, in this case the speakers are not
covered by the manufacturer's warranty.
|
|
|
|
1.
Connect the audio unit connectors and cable.
2.
Install the audio unit.
3.
Install the center facia panel.
...
Front Speaker
1.
Remove the front door trim.
(Refer to Body - "Front door")
2.
Remove the front speaker (A) after removing ...
See also:
Fuel Tank Air Filter Installation
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped.
In this case, u ...
Setup
Display Settings
Press the
key Select
[Display] through
TUNE knob or
key Select
menu through
TUNE knob
Mode Pop up
[Mode Pop up]
Changes selection mode
During On state, pr ...
Crash Pad Replacement
Cluster Fascia Panel Replacement
•
Pry the trim off using a plastic trim tool and apply p ...