1. |
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
|
2. |
Remove the battery (A) and check voltage if the red light doesn't
flicker.
|
3. |
Insert the battery (A) into the tester (09954-2P100).
|
4. |
Push the test button and If "0.00" is displayed on screen, it
means that the battery voltage is 2V or less.
|
5. |
If "L" is displayed on screen, it means that the battery is low
power and it needs to replace.
|
6. |
To prevent the discharge of electricity, turn the tester power
off.
|
7. |
Replace the transmitter battery with a new one, if voltage is
low power then try to lock and unlock the doors with the transmitter
by pressing the lock or unlock button five or six times.
|
8. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, register the transmitter code, then try
to lock and unlock the doors.
|
9. |
If the doors lock and unlock, the transmitter is O.K, but if the
doors don't lock and unlock, replace the transmitter.
|
Anti-Pinch Strip Removal
1.
Disconnect the negative (-) battery terminal.
2.
After loosening the mounting screws, then remove the tailgate
side trim (A).
(R ...
Specification
Pressure
[kPa (kgf/cm², in H2O)
Output Voltage (V)
-3.75 (-0.038, -15.05)
4.5
0
1.5
+1.25 (0.013, 5.02)
0.5
...
Operating door locks from outside the vehicle
Turn the key clockwise to unlock and counterclockwise to lock.
If you lock the driver’s door with a key, all vehicle doors will lock automatically.
From the driver’s door, turn the key to ...