1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front tire wheel guard.
(Refer to Body - "Front bumper")
|
3. |
Turn the bulb socket counterclockwise and then remove the fog
lamp bulb.
|
4. |
If it is necessary to replace the lamp assembly, remove the fog
lamp (A) after loosening the screws.
|
Components Operations
PCM (Power Train Control Module)
1.
The PCM(ECM)(A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transpond ...
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Nut :
7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft)
...
Rear Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Rear Wiper Switch
Rear Washer Swi ...