Kia Sorento: Parking Assist Sensor Removal
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Rear Parking Assist System / Parking Assist Sensor Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
| 3. |
Disconnect the connector (B) from the parking assist sensor (A).
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
Parking Assist Sensor Installation
1.
Install the rear ultra sensor after connecting the connector.
2.
Install the rear bumper cover.
3.
Connect t ...
See also:
Fuel Pressure Control Valve
Fuel Pressure Control Valve is installed on the high pressure fuel pump
and controls fuel flow flowing into the injectors in accordance with the ECM
signal calculated based on various engine ...
Cylinder Block Inspection
1.
Remove gasket material.
Using a gasket scraper, remove all the gasket material from the top
surface of the cylinder block.
2.
Cl ...
Fuel Filler Door Open Switch Inspection
1.
Remove the front door trim panel.
(Refer to Body - "Front door")
2.
Disconnect the switch connector (A) from wiring.
...
Copyright В© www.ksmanual.com 2014-2024