Kia Sorento: Auto Defogging Actuator Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Heater / Auto Defogging Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the cowl side trim.
(Refer to Body - "Crash Pad")
|
| 3. |
Using a screwdriver or remover, remove the crash pad side cover
(A).
|
| 4. |
Disconnect the stopper (B) from the glove box (A).
|
| 5. |
Disconnect the air damper (A) from the glove box (B).
|
| 6. |
Disconnect the pins (A) and then remove the glove box (B).
|
| 7. |
After loosening the mounting screws, then remove the crash pad
side garnish [RH] (A).
|
| 8. |
After loosening the mounting screws, then remove the crash pad
under cover (A).
|
| 9. |
After loosening the mounting screws, then remove the glove box
housing (A).
|
| 10. |
Disconnect the glove box lamp connector (A).
|
| 11. |
Disconnect the connector and then remove the auto defogging actuator
(A) after loosening the mounting screws.
|
| 12. |
Install in the reverse order of removal.
|
Auto Defogging Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defoggin ...
Blower
...
See also:
Circuit Diagram
...
Oil Pan Removal
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the A/C compressor.
(Refer to Heating, Ve ...
Oil hydraulic Motor(Actuator) Installation
1.
Before installation, wipe the surface with a clean cloth.
2.
Check the O-rings (A) of the new hydraulic motor (actuators).
...
Copyright В© www.ksmanual.com 2014-2024