Kia Sorento: Rear Blower Resister Replacement
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Heating,Ventilation And Air Conditioning / Rear Air Conditioner / Rear Blower Resister Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
|
| 3. |
Remove the rear blower resistor (A) after loosening the mounting
screws.
|
| 4. |
Install in the reverse order of removal.
|
Rear Blower Resister Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Controller
...
See also:
Fuel Pump Inspection
[Fuel pump motor]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
...
Rear Oil Seal Installation
1.
Install rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using SST(09 ...
Installation
1.
Install in the reverse order of removal.
If the oil seal on the trans ...
Copyright В© www.ksmanual.com 2014-2024