Kia Sorento: Owner maintenance - Maintenance service - Maintenance - Kia Sorento XM Owners ManualKia Sorento: Owner maintenance

Second Generation XM (2011-2024) / Kia Sorento XM Owners Manual / Maintenance / Maintenance service / Owner maintenance

The following lists are vehicle checks and inspections that should be performed by the owner or an authorized Kia dealer at the frequencies indicated to help ensure safe, dependable operation of your vehicle.

Any adverse conditions should be brought to the attention of your dealer as soon as possible.

These Owner Maintenance Checks are generally not covered by warranties and you may be charged for labor, parts and lubricants used.

Owner maintenance schedule

When you stop for fuel:

WARNING

Be careful when checking your engine coolant level when the engine is hot. Scalding hot coolant and steam may blow out under pressure. This could cause burns or other serious injury.

While operating your vehicle:

At least monthly:

At least twice a year (i.e., every Spring and Fall):

At least once a year:

Scheduled maintenance service

Follow the Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow the Maintenance Under Severe Usage Conditions.

If your vehicle is operated under the above conditions, you should inspect, replace or refill more frequently than the following Normal Maintenance Schedule. After 120 months or 150,000 miles continue to follow the prescribed maintenance intervals.

Maintenance service
You should exercise the utmost care to prevent damage to your vehicle and injury to yourself whenever performing any maintenance or inspection procedures. Should you have any doubts concerning the i ...

Normal maintenance schedule
The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty. Where both mileage an ...

See also:

ESC Control Module Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

Rear Glass Defogger Printed Heater Inspection
   Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on th ...

Battery Installation
1. Install in the reverse order of removal. Battery (-)terminal installation nut: 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft) ...

Copyright © www.ksmanual.com 2014-2024