1. Overrun Alternator Pully (OAP) 2. Front bracket 3. Front bearing 4. Rotor 5. Rear bearing |
6. Rear bracket 7. Through bolt 8. Regulator assembly 9. Regulator bolt 10. Rear cover |
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing
3 screws.
...
Idler Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the idler(A).
Tightenin ...
Circuit Diagram
Connector Pin Information
No.
Wire harness connector
Panorama motor
Blind motor
1
Ground 1 ...