Kia Sorento: Installation
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply the engine coolant to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
|
| •
|
Supplement the engine coolant. (Refer to Engine Mechanical
System - "Coolant")
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
See also:
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from under the steering column.
2.
Che ...
Rear Differential Carrier Disassembly
Rear differential carrier disassembly
1.
Drain oil by removing the drain plug (A) and filler plug (B) before
disassembling the rear differential carrier.
...
Side Impact Sensor (SIS) Installation
Front Side Impact Sensor
•
Do not turn the ignition switch ON and do not connect ...
Removal