(1) Power tailgate open/close button
(2) Power tailgate off button
(3) Power tailgate handle switch
(4) Power tailgate close button
✽ NOTICE
The power tailgate operates when:
WARNING
Never leave children or animals unattended in your vehicle. Unattended children or animals could activate the power tailgate which may result in injury to themselves or others, or damage to the vehicle.
WARNING
CAUTION
Do not close or open the power tailgate manually during automatic operation.This may cause damage to the power tailgate or to the vehicle. If it is necessary to close or open the power tailgate manually when the battery is discharged or disconnected, make sure the tailgate is not in operation. Switch the power tailgate to the off position. Do not apply excessive force.
Opening the tailgate
The power tailgate will open automatically by doing one of the following:
Press the tailgate handle switch carrying the smart key with you.
Closing the tailgate
1. Press the power tailgate close button on the tailgate or inside the vehicle (approximately 1 second).
2. The tailgate will close and lock automatically.
WARNING
The chime will sound and the hazard warning flasher will blink 10 times if you drive with the tailgate closed but not fully secured. Stop your vehicle immediately at a safe place to check if your tailgate is securely locked.
✽ NOTICE
The button on the tailgate will not illuminate or function when the system is in the off/manual mode.
Power tailgate non-opening conditions
WARNING
The chime will sound continuously if you drive over 2mph (3km/h) with the tailgate opened. Stop your vehicle at a safe place as soon as possible to check if your tailgate is opened.
WARNING
The chime will sound and the hazard warning flasher will blink 10 times if you drive with the tailgate closed but not fully secured. Stop your vehicle immediately at a safe place to check if your tailgate is securely locked.
✽ NOTICE
Rear Glass Defogger Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...
Emergency starting
Connect cables in numerical order and disconnect in reverse order.
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle ...
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...