Kia Sorento: Fuel Line Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Line Removal

1.	Turn the ignition switch OFF, and then remove battery (-) cable.

2.	Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")

3.	Disconnect the low pressure fuel quick-connector (A).

4.	Disconnect the vapor hose (A) which is connected from the PCSV.

5.	Lift the vehicle.

6.	Remove the fuel tank. (Refer to Fuel Delivery System - " Fuel Tank")

7.	Disconnect the vapor tube quick-connector (A).

8.	Open the vapor tube and low fuel line fixing clip to using driver.

9.	Release the under cover (A) after remove the mounting bolts.

10.	Disconnect the fuel & brake line protect (A) from the fixing clip.

11.	Disconnect the fuel line fixing bracket (A) to engine room low.

12.	Remove the fuel line.

Fuel Pressure Regulator Installation

1. Install in the reverse order of removal. ...

Fuel Line Installation

1. Install in the reverse order of removal. ...

See also:

Front Wiper Motor Installation
1. Install the wiper motor. 2. Install the crank arm. Torque : 12.7-17.6Nm (1.3-1.8, kgf.m, 9.4-13.0 lbf. ...

Occupant Detection system (ODS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat ass ...

Parking Assist Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") ...

Categories

Copyright © www.ksmanual.com 2014-2025