Kia Optima Manuals

Kia Sorento: Installation - SS-B Solenoid Valve(ON/OFF) - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Installation

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) / Installation

1.
Install in the reverse order of removal.
  
•
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

Inhibitor Switch
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used to control gear setting signals. ...

See also:

Troubleshooting
Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

Cylinder Block Inspection
1. Remove gasket material. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Cl ...

4WD ECU Circuit Diagram and Connector
4WD ECU Connector Pin Function 1 MOTOR A 2 MOTOR B 3 LOCK MODE SWITCH (Input) 4 - ...

Categories


Copyright © www.ksmanual.com 2014-2025