Kia Sorento: Automatic Transaxle Control System
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System
- Description
- Control System Composition
- Component Location
- Circuit Diagram
- Adjustment
- Transaxle Control Module (TCM) Description
- 1. TCM connector and terminal function
- 2. TCM terminal function
- 3. TCM Terminal input/ output signal
- Transaxle Control Module (TCM) Removal
- Transaxle Control Module (TCM) Installation
- Transaxle Oil Temperature Sensor Description
- Transaxle Oil Temperature Sensor Specifications
- Transaxle Oil Temperature Sensor Circuit Diagram
- Transaxle Oil Temperature Sensor Inspection
- Transaxle Oil Temperature Sensor Removal
- Transaxle Oil Temperature Sensor Installation
- Input Speed Sensor Description
- Input Speed Sensor Specifications
- Input Speed Sensor Circuit Diagram
- Input Speed Sensor Signal Waveform
- Input Speed Sensor Inspection
- Input Speed Sensor Removal
- Input Speed Sensor Installation
- Output Speed Sensor Description
- Output Speed Sensor Specifications
- Output Speed Sensor Circuit Diagram
- Output Speed Sensor Signal Waveform
- Output Speed Sensor Inspection
- Output Speed Sensor Removal
- Output Speed Sensor Installation
- Torque Converter Control Solenoid Valve (T/CON_VFS)
- 26 Brake Control Solenoid Valve(26/B_VFS)
- Line Pressure Control Solenoid Valve
- 35R Clutch Control Solenoid Valve(35R/C_VFS)
- Underdrive Brake Control Solenoid Valve(UD/B_VFS)
- Overdrive Clutch Control Solenoid Valve(OD/C_VFS)
- SS-A Solenoid Valve(ON/OFF)
- SS-B Solenoid Valve(ON/OFF)
- Inhibitor Switch
- Shift Lever Components
- Shift Lever Removal
- Shift Lever Installation
- Shift Cable Components
- Shift Cable Removal
- Shift Cable Installation
- Shift Cable Adjustment
Power Flow Chart
P,N
UD/B
LR/B
26/B
35R/C
OD/C
OWC
●
▣ Direction of Rotation
...
Description
Automatic transaxle system relies on various measurement data to determine
the current control status and extrapolate the necessary compensation values.
These values are used to control the a ...
See also:
Crankshaft Damper Pulley Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the passenger engine room side cover.
(Ref ...
Timing Chain Installation
1.
Install the balance shaft chain.
(Refer to Lubrication system - "Balance Shaft & Oil Pump")
2.
Install the crankshaft ...
Blind Spot Detection Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
...
Copyright В© www.ksmanual.com 2014-2024