Kia Sorento: ESC OFF Switch Inspection
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC OFF Switch Inspection
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer the Body - "Crash pad lower panel")
|
| 3. |
Remove the crash pad side switch assembly (A) after loosening
the screws.
|
| 4. |
Check the continuity between the switch terminals as the ESC OFF
switch is engaged.
|
ESC OFF Switch Description
1.
The ESC OFF switch is for the user to turn off the ESC system.
2.
The ESC OFF lamp is on when ESC OFF switch is engaged.
...
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
See also:
Fuel Sender Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the fuel sender connector (A).
...
Rear Driveshaft Components
1. Tone wheel
2. BJ joint
3. BJ boot
4. BJ boot big part band
5. BJ boot small part band
6. Shaft
7. TJ boot small part band
8. TJ boot big part band
9. TJ boot
...
Rear Differential Carrier Reassembly
Pinion drive gear height adjustment
Adjust the height of the drive pinion in the following order.
1.
Below are the special tools to measure the pinion height
...
Copyright © www.ksmanual.com 2014-2024