Kia Sorento: Specification - Engine Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Specification

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Electrical System / Specification

Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.62 ± 10% [20°C (68°F)]
Secondary Coil Resistance (kΩ)
7.0 ± 15% [20°C (68°F)]

Spark plug
Item
Specification
Type
FXU16HR11
Gap
1.0 ~1.1 mm
(0.0394 ~ 0.0433 in.)

Condenser
Item
Specification
Capacitance (uF)
0.47 [1KHz]
Insulation resistance (MΩ)
1,000 [DC 500 V/1 Min]

Charging System
Alternator
Item
Specification
Rated voltage
13.5V, 130A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built-in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C 
Internal mode
-3.5 ± 2mV / °C

※ Regulator Setting Voltage (External mode)
Battery
Item
Specification
Model type
CMF68L-BCI
Capacity [20HR/5HR] (AH)
68 / 54
Cold Cranking Amperage (A)
600 (SAE) / 480 (EN)
Reserve Capacity (Min)
110

  
•
Model type description

•
Cold Cranking Ampere (CCA): Cold Cranking Amps is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.
-
The rating is the number of amps a new, fully charged battery can deliver at -18 °C(-0.4 °F) for 30 seconds, while maintaining a voltage of at least 7.2 volts for a 12 volt battery.
-
The higher the CCA rating, the greater the starting power of the battery.
•
RESERVE CAPACITY (RC) : Reserve Capacity is a battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.
-
The rating is the number of minutes a battery at 26.7 °C(80 °F) can be discharged at 25 amps and maintain a voltage of 10.5 volts for a 12 volt battery.
-
The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.
Starting System
Starter
Item
Specification
Rated voltage
12 V, 1.2 kW
The number of pinion teeth
11
Performance
[No-load, 11 V]
Ampere
Max. 70 A
Speed
Min. 2,400 rpm

Engine Electrical System
...

Tightening Torques
Item N.m kgf.m lb-ft Ignition coil installation bolt 9.8 ~ 11.8 1.0 ~ 1.2 7.2 ~ 8.7 Spark plug installation 14.7 ~ 24. ...

See also:

Folder Random
Press the key   Set [ F.RDM] through the TUNE knob or key to randomly play songs within the current folder. ❈ Press F.RDM again to turn off. Folder Repeat Press the key   ...

Seat Belt Pretensioner (BPT) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Fuel Tank Pressure Sensor (FTPS)
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

Copyright © www.ksmanual.com 2014-2024