Kia Sorento: Limp Home Function - Immobilizer System - Body Electrical System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Limp Home Function

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Body Electrical System / Immobilizer System / Limp Home Function

1.
Limp Home By Tester
If the PCM(ECM) detects the fault of the SMARTRA or transponder, the PCM(ECM) will allow limp home function of the immobilizer. Limp home is only possible if the user password (4 digits) has been given to the PCM(ECM) before. This password can be selected by the vehicle owner and is programmed at the service station.
The user password can be sent to the PCM(ECM) via the special tester menu.
Only if the PCM(ECM) is in status "learnt" and the user password status is "learnt" and the user password is correct, the PCM(ECM) will be unlocked for a period of time (30 sec.). The engine can only be started during this time. After the time has elapsed, engine start is not possible.
If the wrong user password is sent, the PCM(ECM) will reject the request of limp home for one hour. Disconnecting the battery or any other action cannot reduce this time. After connecting the battery to the PCM(ECM), the timer starts again for one hour.

2.
Limp Home By Ignition Key
The limp home can be activated also by the ignition key. The user password can be input to the PCM(ECM) by a special sequence of ignition on/off.
Only if the PCM(ECM) is in status "learnt" and the user password status is "learnt" and the user password is correct, the PCM(ECM) will be unlocked for a period of time (30 sec.).
The engine can be started during this time. After the time has elapsed, engine start is not possible. After a new password has been input, the timer (30 sec.) will start again.
After ignition off, the PCM(ECM) is locked if the timer has elapsed 8 seconds. For the next start, the input of the user password is requested again.

Teaching Procedures
1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedu ...

Diagnosis Of Immobilizer Faults
- Communication between the ECM and the SMARTRA. - Function of the SMARTRA and the transponder. - Data (stored in the EC ...

See also:

Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning directio ...

Piston and Connecting Rod Inspection
Connecting Rod 1. Check the connecting rod end play. Using a feeler gauge, measure the end play while moving the connecting rod back and forth. ...

Air bag
(1) Driver’s front air bag (2) Passenger’s front air bag (3) Side air bag (4) Curtain air bag WARNING Even in vehicles with air bags, you and your passengers must always wear the safety be ...

Copyright © www.ksmanual.com 2014-2024