Kia Sorento: Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
|
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
SS-A Solenoid Valve(ON/OFF)
SS-A solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears.
SS-A Solenoid valve(ON/OFF) is installed at valve body.
...
See also:
Lane Departure Warning System (LDWS) Unit Components
...
Front Body D
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Rear Assist Arm Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright © www.ksmanual.com 2014-2025