Trip Computer
This mode displays driving information like the tripmeter, fuel economy, and so on.
Service
This mode informs of service interval (mileage or days) and warning messages related to TPMS or washer fluid.
User Settings
On this mode, you can change settings of the doors, lamps, and so on.
A/V (if equipped)
This mode displays the state of the A/V system.
Turn By Turn (if equipped)
This mode displays the state of the navigation.
Service Mode
Service Interval
Service in
It calculates and displays when you need a scheduled maintenance service (mileage or days).
If the remaining mileage or time reaches 900 mi. (1,500 km) or 30 days, "Service in" message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position.
Service required
If you do not have your vehicle serviced according to the already inputted service interval, “Service required” message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position (The mileage and time changes to "---").
To reset the service interval to the mileage and days you inputted before:
Press the RESET button
for more than 1 second.
Service in OFF
If the service interval is not set, “Service in OFF” message is displayed on the LCD display.
✽ NOTICE
If any of the following conditions occurs, the mileage and days may be incorrect. The battery cable is disconnected. The fuse switch is turned off. The battery is discharged.
Master Warning Mode (if equipped)
This warning light informs the driver the following situations
The Master Warning Light illuminates when more than one of the above warning
situations occur. At this time, the LCD Modes Icon will change from (
) to (
).
If the warning situation is solved, the master warning light will be turned off and the LCD Modes Icon will be changed back to its previous icon ( ). (ex : refill the washer fluid)
Engine And Transmission Assembly Removal
•
Use fender covers to avoid damaging painted surfaces.
•
...
High Mounted stop lamp Removal
High Mounted Stop Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tailgate trim.
(Refer to Body - " ...
Speakers Installation
Front speaker
1.
Install the speaker to the speaker mounting hole in the door in-panel.
2.
Reconnect the speaker connector.
Rea ...