Description
The trip computer is a microcomputer- controlled driver information system that displays information related to driving.
✽ NOTICE
Some driving information stored in the trip computer (for example Average Vehicle Speed) resets if the battery is disconnected.
Trip Modes (Type A)
To change the trip mode, press the TRIP button
.
Trip Modes (Type B)
To change the trip mode, press the MOVE button .
Trip A/B
Tripmeter (1)
Average Vehicle Speed (2)
✽ NOTICE
Elapsed Time (3)
✽ NOTICE
Even if the vehicle is not in motion, the elapsed time keeps going while the engine is running.
Fuel Economy
Distance To Empty (1)
The distance to empty is the estimated distance the vehicle can be driven with the remaining fuel.
Distance range : 30 ~ 9999 mi or 50 ~ 9999 km.
If the estimated distance is below 30 mi. (50 km), the trip computer will display “---” as distance to empty.
✽ NOTICE
Average Fuel Economy (2)
Manual reset
To clear the average fuel economy manually, press the RESET button
on the steering wheel for more
than 1 second when the average fuel economy is displayed.
Automatic reset
To make the average fuel economy be reset automatically whenever refueling, select the “Auto Reset” mode in User Setting menu of the LCD display (Refer to “LCD Display”).
Under “Auto Reset” mode, the average fuel economy will be cleared to zero (---) when the vehicle speed exceeds 1 km/h after refueling more than 1.6 gallons (6 liters).
✽ NOTICE
The average fuel economy is not displayed for more accurate calculation if the vehicle does not drive more than 10 seconds or 0.03 miles (50 meters) since the ignition switch or Engine Start/Stop button is turned to ON.
Instant Fuel Economy (3)
This mode displays the instant fuel economy during the last few seconds when the vehicle speed is more than 6.2 MPH (10 km/h).
Fuel economy range: 0 ~ 50 MPG or 0 ~ 30 L/100km
Front Strut Assembly Removel
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Propeller Shaft Removal and Installation
1.
After making a match mark on the flange yoke and transfer companion,
remove the propeller shaft mounting bolts (A).
Tightening torque:
...