Kia Sorento: Tire Removal

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Suspension System / Tires/Wheels / Tire Removal

1.	Remove valve core and deflate the tire.

2.

Remove the side of the tire bead area from the wheel using tire changing machine .

•	The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep.

•	Avoid tire/tool contact with the valve on dismount.

•	Dismount should end near the valve.

3.	Rotate the wheel clockwise.

Tire Wear

1. Measure the tread depth of the tires. Tread depth [limit] : 1.6 mm (0.0630 in.) 2. If the re ...

Tire Installation

1. Apply tire soap or lubrication to the top and bottom tire beads. 2. To fit the bottom bead, position the valve at the 5 o’clock pos ...

See also:

Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned according to the following procedure. 1. Check DTC(s) and clear if exist. ...

Inspection
[Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied ...

Pressure Sensor Description
The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque ...

Categories

Copyright © www.ksmanual.com 2014-2024