[1st Method] |
1. |
Start the engine and keep the engine running at idle for 2 minutes.
|
2. |
Step on the accelerator pedal and hold it steady at 4500 rpm with
the shift lever in N position to warm up the engine until the
temperature of the engine coolant reaches 80°C.
|
3. |
Keep the engine running at 2500~3000 rpm in the N position for
15 minutes.
|
[2nd Method] |
|
1. |
Start the engine and keep the engine running at idle for 2 minutes.
|
2. |
Drive the vehicle for over 20 minutes, keeping the engine speed
above 3500 rpm.
|
Blind Spot Detection Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
...
Emergency while driving
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place.
If you ha ...
Water pump Components
1. Water pump pulley
2. Water pump
3. Water pump gasket
4. Water pump housing
5. Water pump housing gasket
6. O-ring
7. Water inlet pipe
...