1. |
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
|
2. |
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
3. |
Drain the coolant.
(Refer to Engine Mechanical System - "Coolant")
|
4. |
Remove the drain plug (A) and reinstall the drain plug after draining
ATF totally.
|
5. |
Remove the wiring bracket installation bolt (A).
|
6. |
Remove the ATF Injection hole(eyebolt) (A).
|
7. |
Disconnect the coolant hose (B) after removing the coolant hose
clamp (A).
|
8. |
Disconnect the hose (B) after removing the automatic transaxle
fluid cooler hose clamp (A).
|
9. |
Remove the valve body cover (A).
|
10. |
Disconnect the oil temperature sensor connector (A).
|
11. |
Remove the oil temperature sensor (A) after removing a bolt.
|
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
1. TCM connector and terminal function
...
Specifications
ON/OFF Solenoid Valve(SS-B)
▷ Control type : Normal low type
Control pressure kpa
(kgf/cm², psi)
490.33 (5.0, 71.12)
Internal resistance(Ω)
...