Kia Sorento: Fuses And Relays

Fuel Filler Door Open Switch Inspection

1. Remove the front door trim panel. (Refer to Body - "Front door") 2. Disconnect the switch connector (A) from wiring. ...

Component Location

1. Start relay #2 (W/O immo./smart key) / ACC relay (With smart key) 2. Start relay #1 3. Windshield deicer relay 4. Power outlet relay 5. Wiper relay (low) 6. Burgla ...

See also:

SRS Control Module (SRSCM) Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Veh ...

IMS Power Seat Control Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...